Haier HVS1200 Operation Manual page 10

Engligh
Introduction of Other Functions
A. Power-off Memory Function:Thewasher has power-off memory function.In case of abrupt power
failure or the power must be cut off during a program cycle, the present settings will be saved and
the preset operation will resume when the power is rezumed. If it needs to cancel this feature,
press Start/Pause key so that the washer will will stop temporarily. Turn off the power key and
restart the washer after a few seconds and the feature will be cancelled.
B. Safety Child Lock Function: During the operation of the program, press down Temperature key and
Load Selection key concurrently and hold for 3 seconds."
program is locked. Repeat the above procedure s to unlock.
C. Foaming Auto-check Function: The washer offers foaming auto- check function, which is is a
solution to incomplete rinse due to over-dispensing of detergent. The washer can sense the
volume of foam formed automatically. When foaming is detected, the Foaming icon in the LCD will
illuminate and an extra rinse cycle will be added before the program completes. Program
time duration will increase automatically.
D. Auto-shower function: With automatic shower rinse technology, it can effi ciently reduce the residual
detergent and make the rinse process more effi cient and thorough. This function operates without
any intervention from human.
E. Display messages:
Err1: Door is not properly shut.
Correction: Shut the door properly.
Err2: Drainage error, water not emptied within 4 min.
Correction: Clean the fi lter and check the drain hose for blockage. If error still exists, please
contact the maintenance personnel.
Err3: Temperature sensor short circuit or open circuit.
Correction: contact the maintenance personnel.
Err4: water heating element damage.
Correction: Contact the maintenance personnel.
Err5: Water fails to meet the specifi ed level within 8 minutes.
Correction: Check the tap and the water pressure, if error still exists, please contact the
maintenance personnel.
Err6: Moter do not work.
Correction: Contact the maintenance personnel.
Err7: Moter overheat protection or damage.
Correction: Restart the power key if still display Err7, contact the maintenance personnel.
Err8: Water exceeds protective level.
Correction: Contact the maintenance personnel.
End: End of a wash cycle.
Unb: After the last rinsing cycle fi nishes, spinning fails completely due to and imbalance of
the laundry.
1:25: Status information: Remaining program time.
" will be displayed indicating that the
8 - EN