Spirit flow-x Function Reference page 325

larger than this value, the status
becomes 'Missing Pulses Channel x'
(with x either A or B)
The value 0 disables the missing
pulses limit check.
Added pulses When the total number of added
limit pulses on channel A or B becomes
larger than this value, the status
becomes 'Added Pulses Channel x'
(with x either A or B)
The value 0 disables the added
pulses limit check.
Simultaneous When the total number of
pulses limit simultaneous pulses on both
channels becomes larger than this
value, the status becomes
Simultaneous Pulses '
The value 0 disables the
simultaneous pulses limit check.
Good pulse reset When the number of good pulses
limit since the last 'bad' pulse has
reached this value, all the bad pulse
count and alarms will be reset
automatically.
The value 0 disables the automatic
reset function.
Bad pulse reset When the value changes the bad
command pulse count and alarms are reset.
Can be used reset the bad pulses
manually or automatically e.g. at a
every new batch.
Error rate limit When the difference in frequency
between the two raw pulse trains is
larger than this limit within the last
calculation cycle, the status
becomes 'Pulse Rate Error'
The value 0 disables the error rate
limit check
Pulse A output Number of digital I/O channel that
channel is used to output the raw A pulses.
0:Not used
1:Digital I/O channel 1
..
16:Digital I/O channel 16
Pulse B output Number of digital I/O channel that
channel is used to output the raw B pulses.
0:Not used
1:Digital I/O channel 1
..
16:Digital I/O channel 16
Pulse A output Used to switch the pulse A output
mode on and off.
0: Pulse output A is disabled
<> 0: Pulse output A is enabled
Pulse B output Used to switch the pulse B output
mode on and off.
0: Pulse output B is disabled
<> 0: Pulse output B is enabled
Flow-X─ Function Reference
Flow-X IO Functions - fxPulseInput
- ADDLIM 0..1e99
- SIMLIM 0..1e99
- RSTLIM 0..1e99
- RSTCMD Any
value
% ERRLIM 0..100
- POCHANA
- POCHANA
POMODA
POMODA
5-325
0
0
0
0
0
0
0
0
0