Rear Suspension - Yamaha SR10RE Operator's Manual

2. When the lubricant has completely
drained from the case and the chain
case is cleaned of old oil, install the
chain case cover. Tighten the cap
screws to 1.2 kg-m (105 in.-lb).
CAUTION
Before installing the chain case screws,
be sure to clean the holes using com-
pressed air completely of debris or
damage to the chain case may occur.
3. Remove the three screws securing
the shift actuator to the chain case,
disconnect the actuator wiring har-
ness, and remove the actuator w/
extension. Pour the recommended
chain lubricant through the shift
actuator opening until the lubricant
is at least halfway up in the sight
glass; then install the shift actuator
w/extension and connect the actua-
tor wiring harness.
18
 NOTE: Make sure the reverse sen-
sor wire is routed up so the wires do
not become pinched between the
actuator and the case.
CAUTION
When installing the shift actuator,
rotate the actuator back and forth to
properly align it with the extension
gear. Failure to do so could cause
component damage.
4. Install and secure the exhaust reso-
nator.
5. Start the engine and verify proper
reverse and forward operation by
shifting in and out of reverse three
times.
CAUTION
The correct lubricant to use in the
chain case is Synthetic Chain Lube.
XM092
Any substitute may cause serious
damage to the drive system.

Rear Suspension

This procedure should be done every 40
operating hours.
NOTE: Yamaha recommends that

All-Temp Grease be used for this
procedure.
1. Using Handlebar Stand or Steering
Post Stand or a suitable substitute,
lay the snowmobile on its left side.
2. Lubricate all grease fittings with all-
temperature grease.