Installation; Connections; Connecting Dmx Signal; Voltage Specification - Flash F7100307 User Manual

LED PAR AURA 64 7x10W RGBW 4in1 ABS F7100307
4

INSTALLATION

After removing the packaging, check if the device was not damaged during transport. Before connecting to
the mains, make sure that the device is securely mounted. The manufacturer is not responsible for damage
caused by unstable mounting.
Ensure proper connection to the mains and proper grounding. Make sure that the electrical parameters are
consistent with device requirements. All activities, including connecting the device to the mains must be
performed by qualified personnel.
5

CONNECTIONS

The device is equipped with the following interfaces:
1. DMX (in/out): XLR 3-pin socket
2. Power (in/out): IEC C14/IEC C13
5.1

Connecting DMX signal

The connection is performed using cable with XLR-female -> XLR-Male plugs.
5.2

Voltage specification

Input Voltage
90~240V
5.3

Connecting power supply

The connection is performed using power cable with IEC C14 connector (included).
The device must be operated by qualified personnel. Make sure that the power grid supply parameters are
consistent with device parameters and limitations are not exceeded.
3
Total Power
70W
Frequency
50/60Hz
www.flash-butrym.pl