Automatically Changing The Shooting Conditions (Auto Bracket) - Pentax OPTIO Optio 750Z Operating Manual

2
Automatically Changing the Shooting Conditions
(Auto Bracket)
Auto bracketing can be used to automatically vary settings such as the
exposure and white balance over a series of three shots when the
shutter release button is pressed. This ensures that you are able to get
the best shots.
Auto Bracket Settings
a
Exposure
b
White Balance
c
Saturation
d
Sharpness
e
Contrast
1
Set the mode dial to a mode other than F, G, C, 7
or O.
2
Press the ( button to display
a.
The icon corresponding to the current setting
appears, and then the setting appears for
approx. five seconds. To take pictures with
the current setting, go to Step 8 below.
Pictures are taken in the following sequence: normal,
underexposed (dark), overexposed (bright). Choose the
bracketing steps from 0.3, 0.7, 1.0, 1.3, 1.7, 2.0. (1p.59)
Conditions change in the following sequence: normal, red tinge
(low color temperature), blue tinge (high color temperature).
Choose the bracketing steps from 1, 2, 3, 4, 5. (1p.95)
Conditions change in the following sequence: Current
Setting, – (low), + (high). (1p.105)
Conditions change in the following sequence: Current
Setting, – (soft), + (hard). (1p.104)
Conditions change in the following sequence: Current
Setting, – (low), + (high). (1p.106)
1
8, 9
4, 5, 6
3, 7
E a b c R d D
Current Setting Current Setting
Exposure Exposure
Change Setting Change Setting
OK
4
0.3EV 0.3EV
63