Using The Wireless Remote Control Function; Pairing With A Receiver - Sony DWM-01 Operating Instructions Manual

1
Turn off the power, and then while
holding down the SET button, turn the
power on.
The signal transmission stops.
2
Press the + or – button repeatedly until
the GP/CH indication is displayed.
3
Hold down the SET button until the
item to be set flashes.
4
Press the + or – button repeatedly to
select a group.
5
Press the SET button to enter the
group.
The channel indication starts flashing.
6
Press the + or – button repeatedly to
select a channel.
7
Press the SET button to enter the
channel.
Note
To start signal transmission with the
selected channel, turn off the power and
then turn it on again.
To set the group/channel
using the pairing mode of the
wireless remote control
function
When the microphone is paired with the
receiver, the transmission channel of the
microphone is set to the receiving channel
on the receiver automatically.
For details, see"Pairing With a Receiver" on
page 20.
20

Using the Wireless Remote Control Function

Using the
Wireless Remote
Control Function
This microphone is equipped with a
wireless remote control function that can be
used to set the parameters (low-cut filter,
attenuation operation, power save mode,
etc.) of the microphone through the receiver
or other devices. This function makes it
easier to operate and manage the
microphone system while in the field.
This wireless control is 2.4 GHz
IEEE802.15.4 compliant and has no effect
on the RF band of digital wireless audio.
This function is activated when pairing is
established between the microphone and
the receiver using the RF REMOTE
function.
Pairing must be done first before the
wireless remote control function can be
used.

Pairing With a Receiver

Pairing links the microphone with the
receiver which the wireless remote control
function is to be used.
When the microphone has been paired with
a receiver through the receiver operation,
turning on the microphone while holding
down the – button establishes the pairing
immediately.
To carry out pairing through menu
operations on the microphone, do the
following.