Table of Contents
Advertisement
GENERATOR ASSEMBLY & SET-UP
1. Set the Generator on a clean, level & dry floor surface and remove the entire carton and all
packaging materials.
2. Check for any external damage and/or missing parts.
3. Install Wheels (Fig A).
- Raise the Front of the Generator Frame approx. 4" and support it securely.
- Insert a Stub Axle (Item 1) through an Axle Tube with the end containing the
drilled hole inward (Fig B).
- Align the horizontal hole in the Axle Tube with the hole in the Stub Axle and slide
a Cotter Pin (Item 2) through.
- Bend the legs of the Cotter Pin apart to retain it in place.
- Place a Wheel (Item 3) on the exposed end of the Stub Axle with the offset protrusion
facing inward.
- Slide a Washer, followed by a Snap Ring (Item 4) over the groove near the end of the
Stub Axle (Fig C).
NOTE: Pliers may be helpful in seating the Snap Ring.
- Repeat above procedure for opposite side.
4. Attach Front Legs (Fig A).
- Raise the Rear of the Generator Frame approx. 4" and support it securely.
- Place a Front Leg (Item 5) with curved edge inward and rubber foot downward over
bend in lower Generator Frame (Fig D).
- Insert two 6mm x 1.75" long screws (Item 6) through the holes in the Leg and
Generator Frame. Tighten with a 10mm wrench on nut and 8mm wrench on
screw head.
- Repeat above procedure for opposite side.
5. Handle
- Rotate handle to the up position then place the 4mm threaded portion of the Handle
Retaining Knob (Item 7) into hole on right upper side of Generator Frame at Handle
base (Fig E). Thread into the spring-loaded, retractable button and tighten
Knob securely.
6
FIG. A
6
5
6
5
FIG. B
FIG. C
FIG. D
FIG. E
Eastwood Technical Assistance: 800.544.5118 >> techelp@eastwood.com
2
3
1
4
Knob (7)
7
Advertisement
Table of Contents
