Linksys AM300 Configuration Manual page 2

Adsl/adsl2+ modem/router

Hide thumbs Also See for AM300:

Modem Configuration Guide

3. RESTORE MODEM/ROUTER TO FACTORY DEFAULTS

PLEASE NOTE: By doing this step you will be deleting any

additional customised settings (if applicable) in your

modem, for example port forwarding. You can change the

configuration of your modem to PPPoE without restoring

the modem to factory defaults in which case please skip

this step and proceed from step 4 however if you experience

Internet problems after competing the setup, we recommend

you do perform step 3 then proceed from step 4

A. Make sure your modem is powered on and connected to

your PC (Network card) via Straight through Ethernet cable.

B. Use a paper clip to depress the reset button at the back of

your modem for 10 seconds and release. At this point the

reset is in progress. Please do not power off the unit.

C. When the indicator lights return steady, the reset is

complete. Your modem is now at factory defaults.

4. CONNECTING USING ETHERNET

A. Connect the Ethernet cable from the back of the unit into an

Ethernet on your computer. Connect the power supply to the

Linksys AM300 and switch the modem on.

B. Open a browser window and type http://192.168.1.1 into the

address bar and click goes.

C. In the login box enter the Username and Password (by

default this is admin for both).

Linksys AM300