Panasonic PT-53X54J Service Manual page 78

http://tsn.pstc.panasonic.com/viewing/NA/PT-53X54J/SVC/s1802000000.html
10. Adjust when the cursor is not flashing by pressing CH up/down and VOL right/left on the remote control, if the cursor
is flashing press MUTE on remote.
11. To move the cursor press MUTE on the remote (cursor flashes), then move the cursor to any of the positions for EASY mode
12. This adjustment may help to make rounded lines become straight lines.
13. Adjust to make lines as straight as possible.
14. Enter to POINT G-POINT (for green) mode by pressing TV/VIDEO.
15. POINT mode allows to move line horizontally and vertically from the perimeter of cursor making rounded lines
become straight
16. In POINT mode, the adjustment data changes by 2 steps, See values on screen by pressing RECALL on remote
17. When the cursor is located in the outer area of the border the cursor starts to flash from one side to other, the location is for
the non-visible area and the most outer side of screen (inside the ovals area, see figure); This applies to LINE, POINT
& ORIGIN.POINT modes.
18. Begin adjustment from the center to the edge of the screen
19. Adjust to make lines as much straight as possible
20. When slightly adjustment is needed, use ORIG. POINT mode.
21. To enter to G-ORIG. POINT (for green) mode press TV/VIDEO.
22. With ORIG. POINT, the adjustment data changes by 1 step, this allows more detail in the adjustment. Display values on
screen by pressing RECALL on remote
23. Confirm that green adjustment is good enough, if adjustment is not satisfactory, repeat adjustments.
24. Enter to LINE G-LINE mode by pressing TV/VIDEO.
http://tsn.pstc.panasonic.com/viewing/NA/PT-53X54J/SVC/s1802000000.html (3 of 5) [23/04/2012 12:16:35 p.m.]
EASY mode adjustment
POINT & ORIG. POINT mode adjustment