PowerTec 365S Operator's Manual page 7

Controls and Operational Features
1. Power Switch and Power Indicator: After input
power is connected and the power switch is turned
on, the indicator will light up to indicate the machine
is ready to weld.
2. Welding Voltage Changing Switches. The
POWERTEC 365S, 425S and 505S have 2
switches (3 and 10 steps).
3. Positive Output Socket: Allows the connection, with
the power cable, to the wire feeder.
4. Wire Feeder Receptacle: 14-pins receptacle for
wire feeder. Provides connections for auxiliary
power of wire feeder. Use source/wire feeder cable
K10347-PG-xxM series or K10347-PGW-xxM
series.
5. Wire Feeder Voltmeter Switch: This switch selects
the polarity of the wire feeder voltmeter, if so
equipped. When welding torch is positive (MIG,
Outershield and some Innershield processes), set
the switch to "+". When welding torch is negative
(most Innershield applications), set the switch to "-".
6. Output Socket with Low Inductance: For connecting
the return welding cable.
7. Output Socket with High Inductance: For
connecting the return welding cable.
8. Fuse: This fuse protects the gas heater socket (see
accessories, K14009-1 CO
9. Fuse: This fuse protects the primary winding of
auxiliary transformer.
10. Covered Hole: For CO
accessories, K14009-1 CO
Socket Kit).
2
gas heater socket (see
2
Socket Kit).
2
11. Cooler Power Supply Socket: For supplying the
cooler unit. The socket has an intermittent output of
230V, 2.5A and is protected by the circuit breaker
[13]. See point [14] for more details.
12. Power Input Cable: Connect the proper plug to the
input cable then into the rated output according to
appropriate rules. Only qualified personnel shall
connect this plug.
13. Circuit Breaker: Protect the Cooler Power Supply
socket [12]. It shuts off the power supply when the
current exceeds 2.5A. Press it to restore the power
supply.
Welding Cables Connections
Insert the plug of the work cable into the socket [6] or [7].
The other end of this cable connects to the work piece
with the work clamp.
Connect the wire feeder to the power source:
•
insert the positive welding cable into the output
socket [3].
•
insert the wire feeder control cable into the
socket [4].
Use the shortest possible cable lengths.
A-3