Advertisement
READ AND FOLLOW ALL INSTRUCTIONS BEFORE OPERATING SYSTEM
Operating the PG2000
Refer to the toggle switch position diagram below for the appropriate switch positions for your particular installation.
The switches are located on the lower right side of the unit. The PG2000 should always operate in manual mode no matter
what type of control system is installed.
When cycling system off, then back on, it may take up to 3-4 minutes before the lamp "restrikes" or comes
back on. The lamp must cool down before restriking. All metal halide lamps have this characteristic and this is
a normal function of the PG2000.
PG2000 Illuminator must have good ventilation to operate properly.
Blockage of air flow or air intake will shorten the bulb life and could
damage the unit. Make sure foliage; grass, groundcover, yard debris, etc.
is kept clear of intake vents on back of the unit in order to allow for proper
air flow. Do not install PG2000 Illuminator in an underground utility box or
similar appliance. Damage to the unit due to blocked air vents or poor
ventilation will void the warranty.
Replacing the Bulb.
1. Turn power to unit off.
Turn off power before changing bulb. Failure to turn off power
may lead to severe electrical shock, which can result in death
or severe injury.
2. Remove two screws securing outer body and lift outer body
straight up.
Bulb socket, and reflector are extremely hot during and following operation.
Allow sufficient time for cooling before touching them, or you may suffer
severe burns.
3. Remove screws (3) at bottom of socket bracket, (see Figure 1.)
and separate socket bracket assembly from reflector.
Remove bulb from socket and insert new bulb. Be sure not to
touch the glass of the bulb.
Do not touch the bulb with your bare fingers - fingerprints can actually cause
the bulb to overheat and crack. Handle the bulb using sheath provided in
packaging.
4. Reassemble socket bracket and make sure bulb is centered in
reflector.
5. Replace outer body and secure with two screws.
P/N 840263
IMPORTANT SAFETY INSTRUCTIONS
CAUTION
WARNING
WARNING
CAUTION
NOTE
TOGGLE SWITCH POSITIONS
REMOTE SWITCH CONTROL
POWER
2
MANUAL CONTROL
COLOR
POWER
POWER
OFF
OFF
ON
RF2000 WIRELESS CONTROL
POWER
COLOR
COLOR
ON
COLOR
Figure 1.
Rev. C 7-29-05
Advertisement
