Table of Contents
Advertisement
www.WorkshopManuals.co.uk
Section G
20 - 1
Service Brakes
Brake Light Switch - Adjustment
1
Select the starter key switch to the ON position, do not
start the engine.
2
With the brake pedal in the return position, adjust
locknuts B and use feeler gauges to set the proximity
switch A so that there is clearance of 2mm MIN - 3mm
MAX between the end of the switch and the brake
pedal lever. The light emitting diode (L.E.D.) on the
switch should be illuminated.
Secure the switch in position by tightening locknuts B.
3
Depress the brake pedal and check the correct
4
operation of the brake lights.
Torque Settings
Item
Nm
kgf m
B
29
2.95
21
9803/3280
Service Procedures
lbf ft
Purchased from www.WorkshopManuals.co.uk
Brakes
A
B
Section G
B
20 - 1
Issue 1
Advertisement
Table of Contents
