Washing Your Atv; Inspection After Cleaning - Baja motorsports Extreme 150 Owner's Manual

WASHING YOUR ATV

With some care, your ATV can be washed in a similar manner to washing an
automobile.
Note: Avoid spraying or allowing water to flow over the following places:
· Ignition switch
· Spark plug
· Fuel tank cap
· Carburetor
Use a garden hose at low pressure to remove the majority of dirt or other debris.
Hand wash your ATV with mild soap or detergent and water. Try to thoroughly remove
all dirt and debris without excessive water pressure, even at remote areas such as
between engine cooling fins, linkages or mounting brackets. Cloth rags, washing mitts
or cleaning brushes can be used. Be careful with brushes as they may scratch plastic
or painted surfaces. Rinse the ATV thoroughly with clean water. Dry all areas using a
chamois or soft absorbent cloth.

INSPECTION AFTER CLEANING

Remove the rags or wrapping from the exhaust pipe. For extended life of your ATV,
lubricate according to GENERAL LUBRICATION section.
Follow the procedures in the INSPECTION BEFORE RIDING section to check your ATV
for any problems that may have occurred during your last ride.
WARNING
Operating the ATV with wet brakes could be hazardous.
Wet brakes may not provide as much stopping power as dry brakes.
This could lead to an accident.
Test your brakes after washing the ATV, riding at a slow speed. If necessary,
apply brake several times to let the friction dry out the linings.
59