Philips PR3094 User Manual page 31

, When the treatment starts, the treatment status
indicator on the TENS units starts to flash yellow.
, The home screen of the remote control shows
the program selected, the treatment time left
and the intensity selected.
, If the intensity feels uncomfortable, press the
- side of the intensity button to reduce the
intensity constantly and slowly.
Note: Since your body initially adapts to the intensity
of the stimulation, you may have to adjust the intensity
level after some time to ensure optimal stimulation.
2 To end the treatment before the set treatment
time has elapsed or if you set the treatment
duration to 'continuous', hold down the - side of
the intensity button for 3 seconds to make the
intensity drop to 0 mA. When the intensity level
is 0 mA, no pulse is emitted by the TENS units.
Note: You can also end the treatment by pressing the
on/off button on the TENS units. In that case, treatment
on both channels stops immediately.
starting and stopping a treatment (PR3094)
To start a treatment, you first have to switch on the
TENS units with the on/off button and then you
press the + sides of the intensity buttons to increase
the intensity.
1 Press the + side of the intensity buttons to set
the intensity for the main and the extension
channel separately and start the treatment.
, Hold down the + side of the intensity button on
the left side of the remote control to increase
the intensity of the main channel. This starts the
pulse between the first two electrodes.
English
31