Converting Burners For Use With Lp\Propane; Converting Type 1 Pressure Regulator For Use With Natural Gas; Converting Type 2 Pressure Regulator For Use With Natural Gas; Converting Burners For Use With Natural Gas - Amana AKO2000 SERIES Owner's Manual

Table of Contents

Advertisement

Converting Burners for Use with
LP\Propane
1. Remove grates, burner bowls, and burner control
knobs from cooktop.
2. Remove 2 screws attaching burner top to burner box.
• Located in burner cutout on outer edge.
3. Remove screws attaching burners to support bracket.
4. Remove burners and venturi tubes.
5. Unscrew orifice hoods and remove.
• Natural gas orifice hood has a larger hole than
LP hood.
• Natural Gas Orifice—#56
• LP Orifice—#68
6. Remove manifold cover.
7. Locate orifice hoods (#68) wired to gas manifold and
screw onto valve.
• Do not overtighten orifice hoods.
8. Attach unused orifice hoods to manifold
for future use.
9. Reassemble cooktop.
Converting Type 1 Pressure Regulator for
Use with Natural Gas
1. Remove pressure regulator cap using a wrench.
2. Remove plastic insert from pressure regulator cap.
• Plastic insert fits tightly in cap.
3. Reverse plastic insert and carefully push plastic
insert firmly into hole in pressure regulator cap.
• Insert must show "NAT" or be blank.
4. Place pressure regulator cap on pressure regulator
and tighten.
• Insert should not disturb spring in body of regulator.
Converting Type 2 Pressure Regulator for
Use with Natural Gas
1. Remove pressure regulator cap using a wrench.
2. Reverse pressure regulator cap.
• Insert shows "NAT" or is blank.
3. Place pressure regulator cap on pressure regulator
and tighten.
Converting Burners for Use with
Natural Gas
1. Remove grates, burner bowls, and burner control
knobs from cooktop.
2. Remove screws attaching burner top to burner box.
• Located in burner cutout on outer edge.
3. Remove screws attaching burner to support bracket.
4. Remove burner and venturi tube.
5. Unscrew orifice hoods and remove.
• Natural gas orifice hood has a larger hole than
LP hood.
• Natural Gas Orifice—#56
• LP Orifice—#68
6. Remove manifold cover.
7. Locate orifice hoods (#56) wired to gas manifold and
screw onto valve.
• Do not over tighten orifice hoods.
8. Attach unused orifice hoods to manifold
for future use.
9. Reassemble cooktop.
6

Advertisement

Table of Contents
loading

Table of Contents