Table of Contents
Advertisement
INSTALLATION.
Installing the printer (retro-fit)
Under normal circumstances the printer will be factory fitted to the control panel. If for any reason
the printer is being replaced or retro-fitted to the control panel:-
Firstly remove the existing control panel lid. Disconnect the key-switch and earth link cables from
the back box, Once removed lift away the lid and fit the new lid in a similar manner, Terminate
cables in line with the Drawing S1620 (see back of manual).
Replacing the paper roll
The printer requires special thermal paper which can be obtained from the suppliers. To fit the
paper roll:-
Vector printer
Installation and Commissioning Manual.
5
Advertisement
Table of Contents
