Nokia 6111 RM-82 Service Manual page 13

CMO Operations & Logistics
Training & Vendor Development
MMultimedia Creation & Support
9.) Remove the Top Keymat. First use a slotted screwdriver
and lever out the Keymat at the marked positions.
11.) Release the snap on the right side of the Display Carrier
Assy...
13.) Release the snap on the left side in the same way like
the right snap. Now open the slide and lift up the Display
Carrier Assy at the Top Keymat side.
For Assembly only!
15.) Round the Main Flex over your finger and fit the UI
Board Assembly with the Main Flex connector together.
Service Manual 6 RM-82
Page 3 (25)
CONFIDENTIAL
10.) Close the slide.
12.) ...with the Dental Tool.
Dental Tool.
14.) Open the Main Flex connector with the SRT-6.
Take care of the surrounding components.
For Assembly only!
16.) Hold the UI Board Assembly and the Slide Assembly
at the top together. Move them both slowly to the shown
direction
Copyright © 2005-2007 NOKIA Corporation. All rights reserved.
Approved 7.0
5.Jan.2007
Note the correct position of the
Note!
MGR