Page 1
T600G Quadcopter User Manual Version 1.0 June 2013...
Page 2
The operator/pilot bears all responsibility for the use of the aircraft. 3. This aircraft contains a large number of sophisticated electronic components that may fail over time. LotusRC and our dealers assume no responsibility for any damage caused by such a failure, be it direct or indirect.
Page 3
Enjoy your new LotusRC product and always fly safely!
In order to provide the best service to you, please purchase this product from LotusRC or one of our authorized dealers. By purchasing our products from us or our dealers, we will be able to better service your needs.
I. Brief Introduction 1. Functions and features The T600G (with GPS) is a high-end aircraft based on the T580P+ platform. It is meant to be used for professional aerial photo and video capture. 1. Safe: Fully independently flight control. Included features are a low voltage alarm and a lost signal auto return to home function.
The T600G supports most camera gimbals which can now be installed under the frame & base plate to allow for quick attachment & removal from the aircraft. The tilt and roll angle can be controlled via the transmitter. The new gimbal mounting location helps in the elimination of high and low frequency vibration during flight.
2. All T600G with full functional test and configured for optimum performance. 3. Ongoing system maintenance and upgrade service support program. Ⅲ. Assembly All of the T600G undergo full flight testing including full assembly, stress test, GPS...
outdoor test and safety test before packaging to ensure the best performance. 1. Main body: a. In folded mode when removed from the packaging b. Press on the corresponding safety pin to release the T600’s 4 arms...
c. Open the Carbon arm and press down to the holding mount until you hear a “click” sound to ensure that it is locked. Press the button 2. Landing gear 1. Pull out the pins on the landing gear one by one...
Page 16
d. Remove prop nuts from the motor and install the propellers. (Please pay attention to the prop center screw thread), rotate the prop by hand till it seats properly and secure it with the prop nuts as picture. You should be able to rotate the prop/motor freely by hand.
Page 17
4. The battery connector is located at the bottom of the frame. Completed Model.
IV. Transmitter/Receiver Information 1. Receiver Connection The T600G is compatible with most 35M, 40M, 72M and 2.4Ghz radios (including: Spektrum, JR, Sanwa, Futaba, Hi-TEC, GWS, WFLY, & ESKY). The sign of GPS control related connector, put in the switch. The default is manual mode, position hold and auto landing.
V. Transmitter channel (CH) and switch (SW) position map: position Flight mode note channel During an emergency, change to manual mode right away to prevent Manual mode aircraft fly away/crash Keep the aircraft flying 1-3mins under manual mode, then change channel 5 to 2 throttle shift.
Page 20
Transmitter also could control direction of aircraft during auto landing. VII. Feedback We would like to hear from you to improve both the product and our services. Please do not hesitate to contact us. Skype: F490905002 www.lotusRC.net Website: Technical services: flying.yan@163.com...