Assembly Instructions - Kiddicare Bedside Crib Assembly Instructions

2. Assembly instructions

Tools required: Allen wrench (provided), Flat head screw driver.
WARNING. Keep young children away from the area you are using to assemble or
dismantle the Bedside Crib. Some of the parts are heavy and could fall on
the child. Some of the fixings are a choking hazard to young children.
WARNING Incorrect assembly or failure to follow these instructions could result in
serious injury or death.
Glue 2 dowels (D) into the two inside holes on the lower rail of the crib end, repeat for the other crib
end. Allow the glue to dry.
Attach the Crib side (2); to the inside face of the Crib end (1) using the Fixing bolts (C) and the Barrel
nuts (B). The crib side should be positioned so that the slot cut into the side rail is on the bottom and
facing the inside of the crib.
Using a screwdriver align the threaded hole of the barrel nut in the corner of the crib side and insert the
fixing bolt, through one of the side support holes in the crib end and into the drilled holes in the ends of
the crib side using the Allen wrench (A) to screw the fixing bolts into the barrel nuts.
Slide the mattress base in to the slot on the crib side so that the base is resting on the 4 dowels in the
crib ends. Attach the second crib end in the crib side making sure that the base locates into the slot of
the crib side . TIGHTEN ALL FIXINGS using the Allen wrench.
DISASSEMBLING THE CRIB
Using the Allan wrench (A) loosen all the Fixing bolts (C). Start by removing the top fixing and work
down. Store all parts not required safely, out of reach of children.
2
B
B
Attaching the crib sides
1
C
C
A
3