Advertisement
PLEASE READ THESE AND RETAIN FOR FUTURE REFERENCE INSTRUCTIONS CAREFULLY
A | Table top | x 1 |
B | Table frame | x 2 |
C | Rear leg support | x 1 |
D | Front leg support | x 1 |
E | Round crossbar | x 2 |
F | Chair frame | x 2 |
G | Seat back | x 1 |
H | Seat base & harness | x 1 |
I | Tray | x 1 |
J | Hexagon key | x 1 |
K | Wooden dowel | x 6 |
L | Screws | x 18 |
To assemble the seat, take the chair frame and push a wooden dowel into each of the two holes which only go part way through the wood (one on each side of the frame).
Fit the seat onto one side of the chair frame and secure with 3 screws. Repeat with the other side.
NOTE: Before securing the chair frames to the seat, ensure that the straps are not twisted.
Ensure all screws are fully tightened before continuing.
Table assembly;
Fit wooden dowels into the larger holes in each end of the Front and Rear leg supports and then fit the supports to the side frame using two screws, referring to the illustration for correct positioning.
Attach the two round crossbars and the table top using 6 screws, but do not tighten fully at this stage.
Repeat with the other side frame, again leaving the screws loose to allow slight movement.
Fit the chair to the table as shown overleaf. Tighten all screws on the table.
To fit the tray, grasp it on both sides and squeeze the two triggers with your fingers. From the front of the seat, slide the tray onto the two plastic runners on the arms of the seat. Release the triggers and move forward or back until the tray locks into place. To adjust or remove the tray, squeeze the triggers and move forwards or backwards as desired.
Always ensure that the locks are properly engaged when using the tray.
Your Combination highchair can be used as a table and seat or as a highchair. To convert to highchair mode, tip the table onto its end with the table top to the rear. Slide the legs of the chair into the slots in the two leg supports. Push down fully to secure.
Regularly check for tightness of screws and that there is no wear or damage to the frame or harness. To clean, use a damp cloth with a little warm soapy water but do not immerse in water. Avoid strong detergents, abrasive or ammonia based cleaners. A light application of good furniture polish may be applied to the frame.
YOUR CHILDREN'S SAFETY IS YOUR RESPONSIBILITY
This highchair has been designed to meet the standard of BS EN 14988:2006 + A1:2012.
Do not leave the child unattended when using this highchair.
Do not use this highchair until your child is able to sit up unaided.
Do not place too close to a source of heat such as electric bar fires, gas fires etc.
Do not use the highchair unless all components are correctly fitted and adjusted.
Ensure that the child is always restrained by the crotch, waist and shoulder straps provided.
Do not position in close proximity to trailing flexes, electric irons, ornaments or other obstacles.
The highchair must always be used on a stable level surface.
Do not use the highchair if any part is broken, torn or missing.
When not in use, store safely away and do not allow to be used as a toy or climbing frame.
Customer Care Hotline For this Product 01692 408802
kiddicare.com
Club Way, Cygnet Park, Hampton, Peterborough, Cambs, PE7 8JA
www.kiddicare.info
Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.
Download Kiddicare Baby Weavers - Combination Highchair Manual
Advertisement
Thank you! Your question has been received!
Need Assistance?
Do you have a question about the BABY WEAVERS that isn't answered in the manual? Leave your question here.