Advertisement
Nextiva S2750e Series
4. If you are using the side cable entry on the dome base, open the
desired hole on the outer case with pliers. Insert the supplied rubber
cap in the dome cable entry.
0.5 inch side entry
0.75 inch side entry
Installation
1. Mount the camera:
On the ceiling or wall, install the dome base on the mounting
surface, using four screws (not supplied).
On an electrical box, use two screws (not supplied).
2. Feed the cables through the bottom or side hole on the outer case.
Ensure that the cables exit out of the hole without being crushed.
© 2007-2009 Verint Systems Inc. All Rights Reserved Worldwide.
3. If the camera uses power-over-Ethernet, refer to the Nextiva
S2750e Series User Guide for the power and Ethernet connections. Go
to step 6.
4. Establish the Ethernet connection of a 12V DC camera by plugging a
cable between the RJ-45 connector at the end of the Ethernet cable
and a device.
5. Power the 12V DC camera. If you are using the universal power supply
sold by Verint:
a. If the electrical plug installed on the power supply is the right one
for the country of operation, go to step d.
b. Remove the installed plug by pushing the PUSH button and
keeping it pushed while turning the plug in the counterclockwise
direction.
c.
Insert the required plug on the power supply then turn it in the
clockwise direction until you hear a click.
d. Tie together the power supply wire with the dashed white lines
and the black wire on the camera using a splice.
e. Tie together the other power supply wire and the red wire on the
camera using a splice.
f.
Power the camera by connecting the electric plug into the outlet.
For any other power supply, refer to the manufacturer documentation
for the proper wiring scheme.
6. Adjust the image to point to the location to be monitored. For the
details, refer to the user guide.
Configuration
To configure the device, you need the SConfigurator software. It is
included on the Verint web site: www.verint.com/manuals. Copy its
executable file (SConfigurator.exe) to the hard disk of your computer.
To make the camera operational in your environment, you need to connect
it to the IP network. Then you complete the configuration with
SConfigurator, the web interface, or your video management software.
1. Ensure that the camera is powered and connected to the Ethernet
network.
www.verint.com/manuals
Installation Guide
3
Advertisement
