Advertisement
Quick Guide GLGP_1003_SPK7:Layout 1
Also connect the non-return valve to the suction hose with a clamp.
1. Put the non-return valve and suction hose into water. Please make sure the pump is higher than
water level at least 300mm.
2. Remove the priming plug and fill water into pump body until it overflows.
3. Replace the priming plug, make sure the delivery hose is open then start the pump.
If under some circumstances, the water doesn´t come out of the outlet, switch off the pump, then
check the non-return valve hasn´t been blocked and there hasn´t been leakage from the suction hose
or connections then repeat above action.
Never let the pump run dry or it will be damaged.
Never run the pump with outlet closed or the pump will be damaged.
PLEASE READ ALL INSTRUCTIONS BEFORE USING THE PUMP
24.06.2008
8:21 Uhr
Seite 3
Fill water into the
pump body until it
overflows
Advertisement
