Related Manuals for Gardenline GLGP 1002
Summary of Contents for Gardenline GLGP 1002
- Page 1 Anleitung GLGP 1002_SPK7:Anleitung GLSP 1002_SPK7 06.08.2007 8:52 Uhr Seite 1 Operating Instructions Garden Pump After Sales Support TEL: 1300 130 579 WEB: www.rossmac.com N16188 1002 GLGP...
- Page 2 Anleitung GLGP 1002_SPK7:Anleitung GLSP 1002_SPK7 06.08.2007 8:52 Uhr Seite 2 Garden Pump What your 2 year warranty means Great care has gone into the manufacture of this product and it should therefore provide you with years of good service when used properly. In the event of product failure within its intended use over the course of the first 2 years after the date of purchase, we will remedy the problem as quickly as possible once it has been brought to our attention.
- Page 3 Anleitung GLGP 1002_SPK7:Anleitung GLSP 1002_SPK7 06.08.2007 8:52 Uhr Seite 3 Table of contents 1. Safety regulations page 4 2. Layout page 4 3. Proper use page 4 4. Operating instructions page 5 5. Fitting the carry handle page 5 6. Electrical connections page 5 7.
- Page 4 Anleitung GLGP 1002_SPK7:Anleitung GLSP 1002_SPK7 06.08.2007 8:53 Uhr Seite 4 Before you put the water pump into operation, one. This work is to be performed only by an carefully read the following safety regulations and the electrician. (See section “Replacing the mains operating instructions.
- Page 5 Anleitung GLGP 1002_SPK7:Anleitung GLSP 1002_SPK7 06.08.2007 8:53 Uhr Seite 5 Media which can be pumped: 6. Electrical connections For the pumping of clear water (fresh water), rain water or mild suds/dirty water. Connect the power cable to a 240 V ~ 50 Hz earthed, 10 amp fuse minimum.
- Page 6 Anleitung GLGP 1002_SPK7:Anleitung GLSP 1002_SPK7 06.08.2007 8:53 Uhr Seite 6 8. Pressure line connection intake hose. Open the water line. Switch on the pump several times for approx. 2 seconds. Most blockages can be removed in this way. The pressure line (should be at least 3/4“) must To drain the pump housing, undo the water drain be connected to the pumpʼs pressure line screw (Fig.
- Page 7 Anleitung GLGP 1002_SPK7:Anleitung GLSP 1002_SPK7 06.08.2007 8:53 Uhr Seite 7 13. Troubleshooting Motor fails to start up Causes Solutions No mains voltage Check voltage Pump rotor blocked -thermostat switched off Dismantle and clean pump No intake Causes Solutions Intake valve not in water Immerse intake valve in water Pump chamber without water connection Fill water into intake...
- Page 8 Anleitung GLGP 1002_SPK7:Anleitung GLSP 1002_SPK7 06.08.2007 8:53 Uhr Seite 8 Never place any electric tools in your household refuse. Seek advice on correct disposal from local waste authorities. The reprinting or reproduction by any other means, in whole or in part, of documentation and papers accompanying products is permitted only Technical changes subject to change with the express consent of ISC GmbH.
Need help?
Do you have a question about the GLGP 1002 and is the answer not in the manual?
Questions and answers