Download Print this page

Edic -mini Tiny xD A69 Operation Manual

Advertisement

Quick Links

EDIC-mini
Tiny xD A69
Digital Voice Recorder
OPERATION MANUAL
Version: June, 2011
© TS-Market

Advertisement

loading

Summary of Contents for Edic EDIC-mini Tiny xD A69

  • Page 1 EDIC-mini Tiny xD A69 Digital Voice Recorder OPERATION MANUAL Version: June, 2011 © TS-Market...
  • Page 2: Specifications

    Short Operating Instruction for Digital Recorder EDIC-mini Tiny xD А69 Specifications: • VAS (Voice Activating System); • Circular recording mode; • Timers to start recording at the preset time; • Information protection system; • Remote microphone connection; • LED indication; • Reading data from the card by a special reader via USB (up to 5,5 Mb/sec). Supplied Software makes it possible to: • Save the recordings on the PC as standard...
  • Page 4: Technical Characteristics

    Technical Characteristics: • Dimensions: 67 x 45 x 8 mm; • Weight: 40g (with rechargeable battery); • Case: Metal; • Memory type: Replaceable Flash xDM card; • xDM card volume: From 150 to 600 hours; • Audio codec: 10-bits; • Frequency band when recording: 100-10000 Hz; • Sensitivity of built-in microphone: up to 9 m; • Signal-to-noise ratio: -80 dB; • Sample rate: up to 22 kHz; • Rechargeable battery type and capacity: 450 mAh, Li-Ion BL-5x; • Battery charging time from USB: 3 hours; • Battery life in record mode: 200 hours (8 K Hz, without compression);...
  • Page 5 Installing Memory Card Install memory card into the compartment as shown in the Figure. The card can be installed and took out only when the switch is in “Stop” position: the LED is not flashing; the recorder is not connected to the PC. Starting the Recording To start recording switch “Rec-Stop” switch to “Rec” position. When the recorder starts recording, the LED flashes five times. While recording, two sequences of flashes indicate a rechargeable battery status and available memory (for more details see Instructions...
  • Page 6 Playing back the Recording Connect USB cable to the Recorder, then to the USB port of the PC. The system recognizes a new storage device. Launch «RecManager.exe» from it. The content of the Recorder is on the left side of the window. Select the recording, right- click and select “Copy to PC”. The recording will be converted to WAV and appears at the right side of the window. To play back the recording left-click it twice. To disconnect the Recorder connect USB cable off the PC, after that connect it off the Recorder.
  • Page 7: Optional Accessories

    Optional accessories: 1. Remote Microphone with compressor; 2. Programmable remote microphone. In Box 1. Recorder; 2. xDM memory card; 3. USB cable to connect to the PC; 4. Instructions. 5. XD Reader...