Advertisement
HORIZ
FREQ
FOCUS
CENTERING
WIDTH
HEIGHT
VERT
LINEARITY
CABINET-REAR VIEW
HORIZONTAL SWEEP CIRCUIT ADJUSTMENTS
Set the Horizontal Hold control to the center of Its range. Adjust
the Horizontal Frequency slug (Bl) until the picture synchronizes
horizontally. Keep turning Bl in the same direction until the pic-
ture Just falls out of sync. Reverse the direction of rotation until
the picture just falls in sync. Rotate the Horizontal Hold control
to both extreme ends of rotation. The picture should either stay
in sync at both ends of rotation or should fall out of sync by an
equal number of bars at each end. If either of these conditions
fail to occur, repeat procedure.
Adjust the Width slug for a picture SLIGHTLY wider than necessary
to fill the picture mask horizontally.
PAGE 2O
Advertisement
