Download Print this page

Power Amplification Section; Preamp Section - Peavey 6534 Operating Manual

Peavey electronics musical instrument amplifier user manual

Advertisement

POWER AMPLIFICATION
SECTION
RATED POWER AND LOAD:
120 W RMS into 16, 8, or 4 ohms
POWER @ CLIPPING:
(Typically @ 5% THD, 1 kHz, 120 V AC
line)
130 W RMS into 16, 8, or 4 ohms
(Bias must be reduced to measure.)
FREQUENCY RESPONSE:
+0, -3 dB, 50 Hz to 20 kHz @ 100 W
RMS into 8 ohms
HUM AND NOISE:
Greater than 75 dB below rated power
POWER AMP EQ:
Active Presence: +10 dB @ 2 kHz
Active Resonance: +10 dB @ cabinet
resonant frequency
POWER CONSUMPTION:
400 watts 50/60 Hz, 120 V AC
(Domestic)
400 watts 50/60Hz, 220-230/240V
(Export)
TUBE COMPLEMENT:
6-12AX7 preamp tubes
(1 for clean/crunch, 3 for Lead, 1 for
EFX and 1 phase splitter
4-EL34 power amp tubes
6534 +

PREAMP SECTION

The following specs are measured @
1 kHz with the controls preset as follows:
Low and High EQ @ 10
Mid EQ @ 0
Bright out
Lead and Rhythm Posts @ 10
Presence and Resonance @ 0 dB
Nominal levels with Pre Gains @ 5
Minimum levels with Pre Gains @ 10
PREAMP INPUT:
Impedance: Very high Z, 470K ohms
Lead Channel (with channel select in):
Nominal Input Level: -60 dBV,
1 mV RMS
Minimum Input Level: -76 dBV,
.15 mV RMS
Clean Channel (with channel select out):
Nominal Input Level: -30 dBV,
30 mV RMS
Minimum Input Level: -34 dBV,
20 mV RMS
Maximum Input Level: 0 dBV,
1.0 V RMS
(Subtract 24 dB with Crunch switch in.)
EFFECTS SEND:
Load Impedance: 47 k ohms or greater
Nominal Output: -10 dBV, 300 mV RMS
Features and specifications subject to change without notice.
EFFECTS RETURN:
PREAMP OUT:
REMOTE FOOTSWITCH:
SYSTEM HUM AND NOISE @
NOMINAL LEVEL (clean channel):
EQUALIZATION:
DIMENSIONS (H x W x D):
WEIGHT:
13
Impedance: Very High Z, 470 k ohms
Designed Level: -10 dBV, 300 mV RMS
Load Impedance: 47 k ohms or greater
Nominal Output: +10 dBV, 3 V RMS
Special 3-button unit with LED indicators
(supplied)
Channel select and reverb
(20 Hz to 20 kHz unweighted)
Greater than 63 dB below rated power
Custom Low, Mid, and High passive type EQ
Push Bright (Rhythm Channel only)
+6 dB @ 2 kHz
Push Crunch (Rhythm Channel only)
Increases gain
10" x 26.625" x 11.75"
(25.4 cm x 67.6 cm x 29.8 cm
48.3 lbs. (21.91 kg)

Advertisement

loading

This manual is also suitable for:

6534+