Razor GROUND FORCE DRIFTER Owner's Manual page 9

REPAIR AND MAINTENANCE
Turn power switch OFF before conducting any maintenance procedures. Before you begin, carefully turn
unit upside down for easier access.
Removing Rear Axle
Tools Required: 5 mm Allen Wrench, 10 mm Wrench, 24 mm Wrench
B
A
A B
A
B
1
Using a 5 mm Allen wrench,
loosen the four (4) seat bolts and
remove seat.
4
Carefully turn unit over and
loosen the two (2) bolts next to the
brake cable.
7
Using a 24 mm wrench, loosen
the lock nut on both rear wheels
and remove wheels. If necessary,
gently tap rear wheel with a rubber
mallet to help loosen wheel off the
rear axle.
Need Help? Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information Need Help? Visit our web site for replacement parts, product support, a list of authorized service centers in the US and customer service contact information
at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service
contact information is listed at the back of this manual. contact information is listed at the back of this manual.
2
Loosen the four (4) 5 mm bolts
(two on each side) on the battery
cover and remove cover.
5
Using a 10 mm wrench, loosen
the nut that holds the brake cable
and pull cable outward.
8
Remove the two (2) "C" clips
(one on each side). Remove the two
(2) brackets that hold the rear axle
in place and remove axle.
3
Remove the eight (8) bolts
(four on each side) that attach the
brackets to the frame.
6
Using a 5 mm Allen wrench,
loosen the four (4) bolts holding the
motor to the frame. Carefully lower
the motor and remove chain from
around the motor sprocket.
7