Razor Ground Force Drifter Installation Instructions

Tools Required:
A. 5 mm Allen wrench
B. 10 mm wrench
C. Flat head screwdriver
WARNING
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect charger
before removing or installing the on/off switch. Failure to follow these steps in the correct order may
cause irreparable damage.
Step 1
Loosen the four (4) 5 mm seat bolts and
remove seat.
Need Help? Visit our web site at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM PST.
( )
Not included
Figure 1
GROUND FORCE

INSTALLATION INSTRUCTIONS

Step 2
Loosen the four (4) 5 mm hex bolts on the battery
cover (2 on each side) and remove cover.
Figure 2a
1
DRIFTER
®
™
ON/OFF SWITCH
W13112445101
Figure 2b