Drain Valve - BREEZEAIR ICON SERIES Owner's Instruction Manual

AUTOMATIC DRAIN VALVE
This air cooler is supplied with an automatic
drain that performs two primary functions:
1. It opens and closes automatically to
control salt concentrations in the tank.
2. It opens to drain all water and keep your
tank dry during prolonged "off" cycles to
protect your health.
Your cooler will automatically change some
of the water during operation when the water
salinity becomes too high. This ensures the
water is always fresh and helps maintain your
cooler in good condition to ensure optimum
cooling performance. This is called "salinity
sensor" method. Alternatively and if
necessary, the air cooler can be set to change
some water after a set time of cooling
operation. The frequency of the automatic
drain function may have been adjusted by
your installer. This is called "timed drain"
method. You can select either method of
water replacement with the following steps.
1.When the cooler is off, press and hold
.
2.While still pressing
3. A number will display which corresponds
to the selected salinity control method as
shown in the table in the next column. Press
or
played number to the desired salinity control
method.
4.Press
DISPLAY NUMBER
00
STANDARD
01
®
, press
to change the dis-
to set your selection.
CONTROL METHOD
SALINITY SENSOR
TIMED DRAIN

DRAIN VALVE

When the air cooler is not operated for
72 hours, the drain valve will open
automatically to empty all water from the
cooler. If necessary, you can adjust this
delay time with the following steps.
1.When the cooler is off, press and hold
2.While still pressing
.
3.A number will display indicating the
current water drain delay time according
to the table.
DISPLAY NUMBER
00
01
02
03
STANDARD
04
Press
your desired delay time.
4.Press
At any time when the wall control is OFF,
you can manually drain the cooler by
pressing and holding
for 1 second. The display will
show "dr" to confirm the operation has
activated.
7
7
, press
DRAIN DELAY TIME
4 Hours
1 Day
2 Days
3 Days
4 Days
or to select
to set your selection.
and