Table of Contents
Advertisement
Quick Links
PinPAC4 Installation
Manual
Version 1.3 September 22, 2015
1
Contents
Warnings and Agreements ................................ 2
1.
What's included in the PinPAC4 Kit ........... 2
2.
Requirements: ........................................... 2
3.
Preparation ................................................ 3
4.
out Board ........................................................... 4
5.
Back Box Installation: Headphone Audio
cable ................................................................... 5
6.
Running the Headphone Audio cable ........ 6
7.
Coin Door Installation PinPAC4: ................ 7
8.
MAC Cable Installation .............................. 8
Coin Door cable Installation .............................. 8
16.
Posi-Taps!............................................... 9
bpog ................................................................... 9
9.
Final Checkout ......................................... 10
10.
Operation and Set audio levels ............ 10
11.
Recommended Headphones. .............. 11
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Pinnovators PinPAC4
Summary of Contents for Pinnovators PinPAC4
-
Page 1: Table Of Contents
Contents Warnings and Agreements ........ 2 What’s included in the PinPAC4 Kit ... 2 Requirements: ........... 2 PinPAC4 Installation Preparation ..........3 Manual Back Box Installation: Subwoofer / Audio out Board ............4 Back Box Installation: Headphone Audio Version 1.3 September 22, 2015 cable .............. -
Page 2: Warnings And Agreements
Back Box Board Pinnovators requires our kit be installed by an experienced Pinball service technician with basic electrical skills. As with any electrical piece of... -
Page 3: Preparation
3. Preparation Unplug the Pinball Machine! Next remove the back glass on the system and open the light board to expose the System circuit board. The Stern KISS SPIKE is shown below as an example. (shown with our sub board already installed) -
Page 4: Back Box Installation: Subwoofer / Audio Out Board
Gently push up on one of the vent screens underneath the pinball machine. A staple holds the screen in place but can be easily remove. Plug supplied Pinnovators 3.5 mm 12ft cable from the subwoofer cable kit into the 3.5mm green jack on the Back Box Board. - Page 5 5. Back Box Installation: Route the cable into the cable harness clip as shown. It may be a tight fit now that you have two cables Headphone Audio cable going through the clip but it will fit. Unwrap the other 12ft 3.5mm audio cable. Insert one end of the cable into the Headphone output jack on the SPIKE CPU board.
-
Page 6: Cable
6. Running the Headphone Audio cable Using a helper, remove the playfield glass and lift up the playfield. Depending on the game, tuck the new cable into the wire harness clips as shown. Leave an extra foot of cable up at the Back Box area if you plan on folding the back box down. -
Page 7: Coin Door Installation Pinpac4
Insert the end of the 3.5mm headphone audio cable nuts as shown. Note: Save the spacers. The spacers into the 3.5mm connector on the PinPAC4 front are used to properly space the length of the screw. control panel as shown. The connector is on the front of the control panel PCB. -
Page 8: Mac Cable Installation
1. MAC Cable Installation Coin Door cable Installation The Front panel should already be installed according to the installation manual included in this kit. These section of the instructions uses a SAM system but the SPIKE is basically the same. If your coin door does not have the inline connector Route the PP4MAC remote cable over the top shown above then please contact us for a Posi-tap... -
Page 9: Posi-Taps
This is a picture of the optional adapter along with a few YouTube video links showing how to install the Posi-Taps. Please watch the video first. (Note, Pinnovators did not make the videos) http://www.youtube.com/watch?v=NQWYWuNbpog http://www.youtube.com/watch?v=Yiimgl-Rdmw Connect the the Posi-tap adapter cable for export... -
Page 10: Final Checkout
8. Final Checkout 9. Operation and Set audio levels Use the up and down buttons to easily set the Power up the system and start a game! Verify sound can be heard from the game audio level. Game level is now completely Back Box speakers and the lower independent of the headphone level! Cabinet speaker. -
Page 11: Recommended Headphones
Exit the service menu Recommended Headphones. Pinnovators tested the PinPAC1, 2,3 and on many different headphones. Our favorite was the beats by dr. dre. We also tested a moderately priced set of headphones ~$30 and was still blown away by how...
Need help?
Do you have a question about the PinPAC4 and is the answer not in the manual?
Questions and answers