Table of Contents
Advertisement
Chapter 5 – Computer Controlled Operation
Command
Code
MØ
TR
TS
UD#
UE#
UI#
UR#
UT#
SAVE
Function
Locks out rear panel controls.
Resets Tare.
Sets Tare.
Sets attached device.
Sets encoder units to # when
device = SPECIAL (UD5).
Selects model.
Sets display torque units to #.
Sets torque scale to # when
device = SPECIAL (UD5).
Saves setup.
16
Magtrol Model 3410 Torque Display
Explanation
Use this command to lock out the rear panel
controls, so that the Torque Display settings
can be changed only by using the computer
with RS-232 interface.
Resets tare to 0 (zero).
Reads current torque and uses as tare value.
Values for # are:
0 = TM(HS) 2XX
1 = TMB 2XX
2 = TM(HS) 3XX
3 = TMB 3XX
4 = TF 2XX
5 = SPECIAL
6 = TF 3XX
# = 1 to 6000
Programmed value # is not saved at power
down.
For measurments to be accurate, the correct
transducer model must be specified.
Note: Refer to table in Section 5.2.2.1 for list
of models and corresponding values.
Programmed value # is not saved at power
down.
Values for # are:
0 = oz·in
6 = mN·m
1 = oz·ft
7 = cN·m
2 = lb·in
8 = N·m
3 = lb·ft
9 = kN·m
4 = g·cm
10 = daN·m
5 = kg·cm
Torque unit conversion defaults to 0 (oz·in) if
out of range.
Programmed value # is not saved at power
down.
# = 0 to 100,000
Programmed value # is not saved at power
down.
Saves values programmed via serial port.
Advertisement
Table of Contents
