Mounting The Camera - Waeco PERFECTVIEW CAM24 Installation And Operation Manual

Mounting the camera

z When laying electric connections, ensure that
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp edged ducts without protection (Fig. 3,
page 4)
z Attach the cables securely in the vehicles to prevent tripping hazards.
Use cable binders, insulating tape or glue the cables in place.
z Protect every through-hole made in the bodywork against water pene-
tration, e.g. by using a cable with a sealant and by spraying the cable and
the the cable sleeve with sealant.
Note!
Do not start sealing the through-holes until all installation work has
been finished for the camera, and the required cable lengths have
been established.
8 Mounting the camera
8.1 Tools required
For installation and assembly you will require the following tools:
z Drill bit set (Fig. 1 1, page 3)
z Drill (Fig. 1 2, page 3)
z Screwdriver (Fig. 1 3, page 3)
z Set of ring or open-ended spanners (Fig. 1 4, page 3)
z Measuring ruler (Fig. 1 5, page 3)
z Hammer (Fig. 1 6, page 3)
z Centre punch (Fig. 1 7, page 3)
To make and test the electrical connection, the following tools are required:
z Diode test lamp (Fig. 1 8, page 3) or voltmeter (Fig. 1 9, page 3)
z Insulating tape (Fig. 1 11, page 3)
z Cable bushing sleeves, if necessary
To fasten the cables you may require additional cable binders.
30
PerfectView CAM24, CAM27