Do you have a question about the Sanibest Pro and is the answer not in the manual?
Questions and answers
Terry R Popa
April 22, 2025
how to vent if i cant use a ceater vent
1 comments:
Mr. Anderson
May 11, 2025
To vent the SFA Sanibest Pro without using a cheater vent, follow these steps:
1. Connect the vent pipe to the 1½" port on top of the unit using the provided waste inlet (labeled J) and secure it with a clamp. 2. Ensure all fixtures connected to the system are also vented. 3. Do not use an air admittance valve or any mechanical spring-loaded venting device, as these are one-way valves and can obstruct airflow. 4. The air pressure inside and outside the macerating unit must remain equal.
This setup ensures proper ventilation according to plumbing codes.
This answer is automatically generated
Matthew
February 4, 2025
How do I connect the toilet to the floor?
1 comments:
Mr. Anderson
February 10, 2025
The Sanibest Pro toilet must be connected to the rear discharge toilet that is part of the system. It should be placed in the same room as the toilet and other connected fixtures. The installation includes securing the unit using the provided fixing brackets. The unit must be easily accessible for maintenance.
Page 1
03.12 IND1 IMPORTANT DO NOT RETURN ANY MERCHANDISE TO THE VENDOR NE PAS RETOURNER DE MARCHANDISE AU VENDEUR For Customer Service, Returns or Technical Questions, please call Saniflo’s technical support toll-free at 800-571-8191 (USA) or 800-363-5874 (CDN). Pour le service client, les retours ou toute question technique, merci d’appeler le service technique de Saniflo au numéro suivant : 800-571-8191 (USA) ou 800-877-8538 (CDN).
Page 2
2" x 1-1/2" 90 X 110 32 X 55 25 X 40 2" x 2" 1-1/2" 20 X 32 x 1-1/2" 50 X 70 Flow rate (liters/min) 25 Ft 21 Ft 18 Ft 15 Ft 12 Ft 9 Ft 6 Ft 3 FT Flow rate (gallons/min) Ø...
Page 3
7 SUITE SANIBEST Pro ® SFA SANIFLO INC 120 V - 60 HZ - 9A - 1 HP - IP44 -...
3 - Push the metal clamp around the flexible sleeve and or directly from pump appliances such as a dishwasher. then pull the sleeve over the exit spigot of the bowl Installed and used correctly, the SANIBEST Pro ® will give 4 - Position the metal clamp at the edge of the flexible consistent and reliable service.
Page 5
USAGE The normal domain of application of SFA units only CONNECTION OF SANITARY FIXTURES concerns the disposal of human waste, toilet paper and The unit is equipped with two additional 2”...
Page 6
SYMPTOM PROBABLES CAUSES REMEDIES • The motor intermittently • The toilet tank or taps are • Check the appropriate activates dripping washers / seals on the tank / taps etc • The non-return valve • Clean or replace the is faulty non-return valve •...
Page 7
ADVICE VERTICAL INSTALLATION FIRST PIPE SUPPORTS If vertical lift is required, this must precede the horizontal pipe All sanitary pipe work must be run. supported, in accordance with the pipe manufacturerʼs recommendations. Avoid dipping or trapping, which may EASY ACCESS cause the build up of residual “solids”...
Page 8
WIRING DIAGRAM / SCHEMA DE CABLAGE 10 11 n° Description Descriptif Green/Yellow motor Vert /Jaune moteur Green/Yellow power cable Vert / Jaune câble alimentation Brown pressure gauge level Marron pressostat niveau Brown pressure gauge level Marron pressostat niveau Brown power cable Marron câble alimentation Brown motor Marron moteur...
2 Year Warranty from Date of Purchase Subject to the terms and conditions set out below, SFA-SANIFLO INC., (hereafter designated the as the Company) warrants that it will repair or replace the product or any of its component parts, at the Company’s discretion if it deems that the product or part it is defective or does not meet the rated...
Page 10
à laver au moyen d’un RACCORDEMENT DE LA TOILETTE branchement indirect (un évier de service). 1 - Enfiler le manchon souple sur le raccord d’entrée au Le SANIBEST Pro ® est conçu pour l’élimination des déchets caisson.
Page 11
UTILISATION métalliques. 2 - Si ces entrées ne sont pas utilisées, boucher l’entrée Les unités de SFA doivent uniquement servir à l’élimination inutilisée avec l’embout fourni après avoir graissé le des déchets d’origine humaine, du papier hygiénique et de l’eau.
Page 12
Libérer et soulever le couvercle, puis débrancher la gaine de liaison à partir de la jauge de pression 54 and 55 . Avertissement : Avant toute intervention sur le Sanibest Pro ® d) Retirer le moteur.
Page 13
CONSEILS LA TUYAUTERIE VERTICALE D’ABORD ANCRAGE DES TUYAUX Lorsquʼon installe des tuyaux à la verticale, il faut les poser avant Tous les tuyaux des installations sani- de poser les tuyaux horizontaux. taires doivent être ancrés conformément aux recommandations du fabricant pour les empêcher de pendre, car ils ACCÈS FACILE pourraient alors être bloqués par une...
Page 14
WIRING DIAGRAM / SCHEMA DE CABLAGE 10 11 n° Description Descriptif Green/Yellow motor Vert /Jaune moteur Green/Yellow power cable Vert / Jaune câble alimentation Brown pressure gauge level Marron pressostat niveau Brown pressure gauge level Marron pressostat niveau Brown power cable Marron câble alimentation Brown motor Marron moteur...
GARANTIE LIMITÉE Garantie de deux ans à partir de la date d’achat Sous réserve du respect des conditions énoncées ci-dessous, SFA-SANIFLO INC. (ci-dessous appelée “la Compagnie”) garantit qu’elle réparera ou remplacera, à son gré, le produit ou l’une quelconque de ses pièces, qui de l’avis de la Compagnie, se trouve défectueux ou ne répond pas à...
Need help?
Do you have a question about the Sanibest Pro and is the answer not in the manual?
Questions and answers
how to vent if i cant use a ceater vent
To vent the SFA Sanibest Pro without using a cheater vent, follow these steps:
1. Connect the vent pipe to the 1½" port on top of the unit using the provided waste inlet (labeled J) and secure it with a clamp.
2. Ensure all fixtures connected to the system are also vented.
3. Do not use an air admittance valve or any mechanical spring-loaded venting device, as these are one-way valves and can obstruct airflow.
4. The air pressure inside and outside the macerating unit must remain equal.
This setup ensures proper ventilation according to plumbing codes.
This answer is automatically generated
How do I connect the toilet to the floor?
The Sanibest Pro toilet must be connected to the rear discharge toilet that is part of the system. It should be placed in the same room as the toilet and other connected fixtures. The installation includes securing the unit using the provided fixing brackets. The unit must be easily accessible for maintenance.
This answer is automatically generated