Ambient Weather WeatherBridge Quick Start Manual page 5

The following table summarizes the USB version for most weather stations:
Ambient Weather (WS-1080, WS-1090, WS-2080)
Davis Instruments VantagePro, VantagePro2 and VantageVue 6510USB and
6520 WeatherLink Data Logger
Fine Offset WH-1080, WH-2080, WH-3080
Honeywell / Meade TE923, TE827, TE821, DV928, Hideki, Mebus, IROX
La Crosse/ELV: WS-2300 Series, WS-300-PC, WS-300-PC-2, WS-300-PC-US,
WS-444, WS-500 , WS-550-Technoline, WS-550-US, WS-550-2-US, WS-777,
WS-888, WDE1
Oregon Scientific WMR-88, WMR-100, WMR-200, WMRS-200
Peet Bros: Ultimeter 100/800/2000/2100/II (requires USB to Serial
Converter)
Rainwise MKIII Series, serial data logger
USB to Serial converters
Use USB Hub for 1.X. No USB hub required for 2.0.
2. Connect the WeatherBridge to your router or switch.
Note: a cabled connection is required to configure the device. It can later be disconnected
after the optional WiFi LAN is configured.
3. Connect the AC power adaptor to the WeatherBridge. The power light will turn ON
(reference Figure 4).
The Status/Reset light will flash slowly, then rapidly, then solid green. This process can take
several minutes. Once the status/reset light is solid green, you are ready to begin.
If it does not turn green, and continues to flash rapidly, it has not made a connection to the
Internet. Check your connections and firewall settings.
Note: If you have a Davis Instruments WeatherLinkIP 6555 data logger, reference Section
Version 1.10
Weather Station
Figure 4
Status Lights
©Copyright 2016, Ambient LLC. All Rights Reserved.
(requires USB to Serial Converter)
USB
1.X
1.X
1.X
1.X
1.X
1.X
Check
your
device
Check
your
device
Check
your
device
Page 5