Remove The Fresh Food Door Handle; Remove The Freezer Door Handle - GE PFS22SISBSS Owner's Manual

Installation instructions
[] REMOVE THE FRESH FOOD
DOOR HANDLE
(For placement in the installation location or
reversal of the handles - on some models)
Stainless steel (on some models):
@ REMOVING
THE DOOR
HANDLE: Loosen
the set screws
with the 3/32"
Allen wrench
and remove
the handle. NOTE:
For Double Door
models follow the
same procedure
on the opposite
door.
O REVERSING THE
DOOR HANDLE:
• Remove the
O _€'adge
lug
utton
of
Mounting
Fasteners
(appearance may vary)
handle mounting fasteners with a 1/4" Allen
wrench and transfer the handle mounting
fasteners to the right side.
• Remove and transfer the plug button and
logo badge to the left side of the fresh food
door. NOTE: Use a flat plastic edge to prevent
damaging the door. Remove any adhesive on
the door with a mild detergent. Remove the
paper covering on the adhesive backing on
the logo badge prior to carefully attaching the
badge to the door.
Plastic handle (on some models):
@ REMOVING
THE DOOR
HANDLE: Slide
the handle up
on the handle Badge
mounting
fasteners and
remove the
handle.
O REVERSING THE
DOOR HANDLE:
• Remove the
handle
Button
mounting
Mounting Fasteners
fasteners with a
3/8" or 10 mm (appearance
may
vary)
socket wrench and transfer the handle
mounting fasteners to the right side.
• Remove and transfer the plug button and
logo badge to the left side of the fresh food
door. NOTE: Use a flat plastic edge to prevent
damaging the door. Remove any adhesive on
the door with a mild detergent. Remove the
paper covering on the adhesive backing on
the logo badge prior to carefully attaching the
badge to the door.
After removing the handle: Move the small plug
button from the top right side of the door top and
insert it into the hole on the opposite side.
(appearance may vary)
[] REMOVE THE FREEZER DOOR
HANDLE
Stainless steel handle:
@ Loosen the set screws located on the underside
of the handle with the 3/32" Allen wrench and
remove the handle.
NOTE: If the handle mounting fasteners need to
be tightened or removed use a 1/4" Allen wrench.
Plastic handle:
@ Slide the handle to the right on the handle
mounting fasteners and remove the handle.
NOTE: If the handle mounting fasteners need to
be tightened or removed use a 3/8" or 10 mm
socket wrench.
Mounting
fasteners
(appearance may vary)
Slots on back
of handle
19