Table Of Contents - VERITAS Mk.II Honing Manual

Table of Contents

Lapping2
Mk.ii Honing Guide Components2
Setting The Honing Guide3
Lapping The Face3
Configurations For Different Bevel Angle Requirements3
Setting The Registration Jig4
Registration Jig Installed4
Honing The Primary Bevel5
Step 4: Installing The Blade5
Honing The Micro-Bevel6
Back Bevels6
Micro-Bevels6
Bevels On A Plane Blade6
Setting Other Angles8
Set-Up For Very Low-Angle Back Bevels8
Registration Stop Hole Locations8
Obtaining Other Angles By Adjusting Wheel Setting Knob9
Standard Angles9
High Angles9
Back-Bevel Angles9
Obtaining Other Angles By Adjusting Blade Projection10
Measuring Blade Projection10
Honing Guide Maintenance11
Locations To Oil Roller11
Accessories12
Narrow-Blade Carrier Components14
Mounting The Narrow-Blade Carrier Onto The Straight Roller Base14
Connecting The Registration Jig Onto The Narrow-Blade Carrier15
Installing A Chisel15
Skewed Micro-Bevel Interface16