Mode Selection; Measurement; Automatic Point Detection - schwa-medico Pointoselect Digital DT Instruction Manual

Mode Selection

Press the M key to select the modes.
M
auto Automatic Mode
M
man Manual Mode
S
Stimulation
To adjust stimulation settings
Press the E key to select Ear or Body mode.
These options can only be selected in „automatic measurement" and „manual measurement" modes.
Ear
All ear points are detected.
Both sensors of the hand probe are required for measurements.
Go Ear gold
Only gold points are detected and displayed on the device.
Both sensors of the hand probe are required for measurements.
Si Ear silver
Only silver points are detected and displayed on the device.
Both sensors of the hand probe are required for measurements.
Body
Exclusively the inner sensor is used for measurements in the body mode. Gold
and silver point detection is not active and therefore not displayed.

Measurement

The lower the sensitivity is (few bars on the display and deep acoustic signal), the more relevant the
point is for treatment.
Many bars on the display and high acoustic signal symbolize high sensitivity measurement and notify
many points around the area.

Automatic Point Detection

Both inner and outer sensors of the hand probe are required to search for ear
points. The sensitivity changes automatically and is displayed with bars and
respectively a number on the screen.
Each sensitivity level is attributed to a specific acoustic signal.
The fewer the bars the more precisely you have detected the acupuncture point
(very point).
6 Pointoselect Digital DT | Instruction Manual