Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for B-Speech sora
Summary of Contents for B-Speech sora
-
Page 2: Fcc Information
FCC Information This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received; including interference that may cause undesired operation. Federal Communications Commission (FCC) Statement This Equipment has been tested and found to comply with the... - Page 3 - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. - Consult the dealer or an experienced radio/TV technician for help.
-
Page 4: Package Contents
It uses BT 2.1 and multilink tech- nology, but is also compatible with mobile phones using ver- sion 1.1 technology. Your B-Speech® SORA headset uses a built-in Lithium Polymer rechargeable battery, with long life. Package Contents •... - Page 5 6. Mulitfunction key 7. Status LED 8. Earhook hinge 9. Charging port The headset can be worn on either ear. Just clip the ear hook on to the preferred side. - 5 -...
-
Page 6: Charging The Internal Battery
1. Connect the USB Charger to a USB port. 2. Plug the adaptor's connector into the charging port of SORA 3. While charging, the red LED light will stay on and turn off when charging is complete. You can then unplug the adaptor's connector from the headset and disconnect the adaptor from the electrical outlet. -
Page 7: Pairing Procedure
Note, if there is no connection with B-Speech® SORA, the headset will switch off automatically. After switching on , Sora will go into auto-pairing mode and connect to the mobiles, which were paired before Pairing Procedure Your B-Speech® SORA needs to be paired to your Bluetooth®... -
Page 8: Phone Call Use
Please proceed with pairing as described before. To activate the Multi-link-function please press volume -/+ at the same time for 3 seconds. B-Speech SORA will get into the multilink Mode, the Blue LED will blink twice. Phone call use... - Page 9 simply press the multi-function key. Note that you can set your mobile phone to automatically answer calls, which means you do not even need to press the multi-function key. Please refer to your mobile phone's user guide for more information about this setting. Note for Multi-link use: You must end the first call before you can receive the incoming call of the second mobile ( to be automatically re-paired with the second mobile takes 6 -7...
- Page 10 port this function. Press the multi-function key briefly. You will hear a short tone. Speak the voice tag immediately. Your phone will make the call. Last number redial When the headset is in standby mode (not in conversation), press the volume + key 3 seconds, (tone appear) and your phone will re-dial the last number that you called.
-
Page 11: Adjusting The Volume
Registration and Safety Certification/General Information This device bears the CE symbol as specified by the provisions of Directive R & TTE (99/5/EC). B-Speech hereby declares that this device is in compliance with the basic requirements and other relevant guidelines and regulations... -
Page 12: Note On Environmental Protection
You will find the declaration of conformity on the Internet at http://www.b-speech.com. Note on environmental protection: After the implementation of the European Directive 2002/96/ EU in the national legal system, the following applies: Electrical and electronic devices may not be disposed of with domestic waste. - Page 13 The Bluetooth word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by D-Parts is under license. Other trademarks and trade names are those of their respective owners.
Need help?
Do you have a question about the sora and is the answer not in the manual?
Questions and answers