Table of Contents
Advertisement
Available languages
Available languages
PROBLEM
Air is leaking near
the top of the tool or
the trigger area.
Tool does nothing or
operates sluggishly.
Air is leaking near the
bottom of the tool.
Tool is jamming frequently.
Other
TROUBLESHOOTING
PROBLEM CAUSE
• Loose screws.
• O-ring is possibly worn out.
• Inadequate air supply.
• Inadequate lubrication.
• O-rings or seal is worn or damaged.
• Loose screws.
• O-ring is possibly worn out.
• Incorrect fasteners
• Damaged Fasteners.
• Magazine or nose screws are loose.
• Magazine is dirty.
• Driver is worn or damaged.
SERVICE AND REPAIRS
l All quality tools eventually require some servicing of replacement parts due to wear
from normal use.
l If your tool requires service, ask your retailer or call us at 1 (888) 267-7713 for an
authorized repair centre in your area. All repairs made by local authorized repair
centres are fully guaranteed against defective material and workmanship.
l Some user-serviceable components are described in the Troubleshooting section. We
cannot guarantee repairs made or attempted by anyone other than authorized
agencies.
l Questions? Feel free to call our technical support department toll-free at
1 (888) 267-7713. In any communication, please be prepared to give all the
information about your tool: model number, type, serial number, etc.
GUARANTEE
Thank you for investing in a RONA tool. These products have been made to demanding,
high quality standards and are guaranteed for domestic use against manufacturing faults
for a period of 36 months from the date of purchase.
This guarantee does not affect your statutory rights. In case of any malfunction of your
RONA tool (failure, missing part, etc.), please call us toll-free at 1 (888) 267-7713. In any
communication, please be prepared to give all the information about your stand: model
number, type, serial number, etc.
Normal wear and tear, including accessory wear, is not covered under guarantee. The
product is guaranteed for 36 months if used for normal trade purposes. Any guarantee
is invalid if the product has been overloaded or subject to neglect, improper use or an
attempted repair other than by an authorised agent. Heavy duty, daily professional or hire
usage are not guaranteed. Due to continuous product improvement, we reserve the right to
change the product specification without prior notice.
CORRECTION
• Tighten the screws.
• Replace damaged or worn O-ring.
• Make sure air supply is adequate.
• Place two or three drops of oil to the air inlet of
•
the tool.
• Tighten the screws.
• Replace damaged or worn O-ring.
• Supply approved fasteners of the correct size.
• Replace undamaged fasteners.
• Tighten screws.
• Clean magazine.
• Replace damaged or worn components.
• Contact RONA technical support department:
1(888) 267-7713
•
13
070709
Advertisement
Table of Contents
