Maintenance; Troubleshooting - Rona RFNS-001 Operator's Manual

OPERATING INSTRUCTIONS
FASTENER DEPTH
The depth to which a fastener is driven is controlled by the depth adjustment (A). The
depth drive is adjusted to the maximum setting by the factory.
TO ADJUST
1. Loosen Screw (B), slide the adjustment to the desired position and retighten the
locking screw.
NOTE:

Sliding the safety bracket (A) upward increases the depth of the drive.

Sliding the safety bracket (A) down decreases the depth of the drive.
2. Test fire another fastener in a scrap work piece and check the depth. REPEAT AS
NECESSARY UNTIL DESIRED DEPTH IS ACHIEVED. The amount of air pressure
required will vary depending on the size of the setting. To determine the lowest setting
that will consistently perform the job at hand. Air pressure in excess of that required
can cause premature wear and/or damage to the tool.
3. A rubber nose cushion (C), is provided to reduce marring of the work surface. The
rubber cushion can be removed to increase the depth of the drive.
CAUTION: Disconnect tool from the air supply before removing or installing the rubber
cushion.
Don't use the tool without nails in the magazine. When there are only two or three nails left
in the magazine, the tool may misfire. It is not necessary to take the nails out. Simply place
a new strip of nails in the magazine and operate normally.

MAINTENANCE

CLEARING A JAMMED FASTENER
CAUTION: Disconnect the tool from the air supply.
1. Remove any remaining fasteners from the nailer.
a. Pull feeder all the way to the rear until it latches
b. Slide the fasteners to the rear, and remove fasteners from the magazine
2. Use a pair of needle nose pliers and/or a flat screwdriver to remove bent fasteners
from the back of the nosepiece. If fastener cannot be removed as described, it may
be necessary to disassemble the magazine as follows:
a. Remove three screws (RFNS-001-68 & RFNS-001-65 on the left front of the
magazine and remove screws RFNS-001-35 on the right front.
b. Remove support (RFNS-001-73)
c. Slide the magazine back, off the nosepiece.
d. After clearing bent fastener, reassemble in reverse order.
REGULAR MAINTENANCE

Clean and inspect the tool daily. Make sure the tool is disconnected from the air supply.

Blow the tool clean with compressed air and inspect for wear or damage. Use
non-flammable cleaning solutions to wipe the exterior of the tool only if necessary. DO
NOT SOAK tool with cleaning solutions. Such solutions can damage internal parts.

Inspect the trigger and the safety mechanism to assure the system is complete and
functional. Check for loose or missing parts, and any parts that may be sticking.

Keep all the screws tight. Loose screws may cause personal injury.

Place two or three drops of pneumatic oil (included) into the air inlet of the tool daily.

TROUBLESHOOTING

12
RFNS-001
A
B
C
Fig. 5