Power Supply - Kurzweil MPG100 User Manual

MPG100_Manual_G03_161009.ai 8 2016/10/9 16:17:38 MPG100_Manual_G03_161009.ai 8 2016/10/9 16:17:38
Setup
STEP 3:
Place one end of the pedal support rods ④ into the rear of
the pedalbox, then line up the other end of the rod to the rod
holes on the underside of the main cabinet. Use the 8
screws ⑤ provided to secure the rods.
STEP 4:
Move the piano into an upright position. Three persons, one
near each leg, lift the piano body straight upward with legs
parallel to the floor. Then tilt backward until all 3 legs are
vertical. Finally, lower the body until the legs touch the floor.
To avoid possible damage, do not let the piano rest on any
of the legs until the legs are all vertical.
C
M
Y
STEP 5:
CM
Finally, connect the pedal cable to the pedal jack at the rear
MY
bottom of the Piano.
CY
CMY
K

Power Supply

1. Before connecting to power supply, please set the [POWER] button
to OFF and set the master volume to minimum level.
2. Connect the power cable to an AC outlet.
Press the [POWER] button, the LED display lights up, indicating the
3.
piano is powered on.
08
5
4