Advertisement
The Problem solver
(continued)
PROBLEM
POSSIBLE CAUSEAND REiMEDY
WATERWON'TPUMP
If
the entire bottom of the tub has water, you may have a drain problem. Clean the air
OUT
OF THE TUB
gap, if you have one. (See page 19.)
Check the kitchen sink. Is it draining well? Youmay need a plumber.
If dishwasher drains into a disposer, run the disposer to clear. Be sure the disposer is
not clogged.
See the SYSTEMS MONIIXIR (pages 7 to 9).
SUDS IN THE TUB
Sudsing detergents are not meant for dishwashers. USE ONLY AUlOMATIC
DISHWASHER DETERGENTS 'IO AVOIDSUDSING.
To remove suds from the tub:
Open the dishwasher. Let suds evaporate. Add 1 gallon
of cold water to the tub. Close and latch the dishwasher. To pump out water, touch
START two times, then immediately touch CLEAR-RESET.
Repeat if necessary.
DISHWASHER LEAKS
Suds can cause unit to overflow. That's why it's so important to use a detergent that's
designed for automatic dishwashers.
Spilling the rinse agent can cause foam during washing. This can lead to overflowing.
Wipe up accidental spill of rinse agent with a damp cloth.
CONTROL PANEL
Shut off power from dishwasher at fuse or circuit breaker. Wait 5 seconds and restore
DOESN'T RESPOND
power to dishwasher. Try input panel again.
'IQ INPUTS
If you need more help.. call, toll free:
GE Answer Cente#
800.626.2000
consumer information service
18
Advertisement
