Table of Contents
Advertisement
Available languages
Available languages
Tfal-EZCLEAN-2016217114_Tfal-EZCLEAN-2016217114 07/12/09 15:07 Page8
Thank you for buying this T-fal appliance, which is intended for domestic use only.
ENG
Read the instructions in this leaflet carefully and keep them within reach. They
apply to every version depending on the accessories that come with your appliance.
Any commercial use, inappropriate use or failure to comply with the instructions, the
manufacturer accepts no responsibility and the guarantee will not apply.
T-fal SA has an ongoing policy of research and development and may modify these pro-
ducts without prior notice.
For your safety, this product conforms to all applicable standards and regulations.
Installation
• Never place the appliance directly on a fragile surface (glass table, tablecloth, varnished
furniture, etc.) or on a soft surface such as a kitchen towel.
• Do not place the appliance on or near slippery or hot surfaces; never leave the electri-
cal cord over a source of heat (hotplates, gas cookers, etc.).
• Open the appliance.
• Remove all packaging, stickers or various accessories from the interior and exterior of
the appliance.
• Cooking fumes may be dangerous for animals which have a particularly sensitive
respiratory system, such as birds. We advise bird owners to keep them away from
the cooking area.
• Before first use, wash the plates (follow paragraph after use), pour a little cooking
oil onto the plates and wipe with a soft cloth or paper kitchen towel.
surplus oil using clean kitchen paper towel.
Choice of plates
• According to the model, you may use different sets of plates.
• Make sure that the appliance is cold and unplugged before changing the plates.
• To remove the plates (
- Press the release buttons while holding the plate in place, then pull it out using the
handles on either of its sides.
• To replace the plates (
- Place the plate at an angle with the slots below the stops.
- Press down on the plate to lock it down.
Connection and pre-heating
• Close the appliance.
• Fully unwind the electrical cord.
• Plug the electrical cord into the wall socket:
the light red comes on (
• Leave the appliance to pre-heat:
the green light comes on when the correct cooking temperature is reached.
• Do not touch the hot surfaces of the appliance but use the handle.
8
B
) Open the appliance (
C
)
D
)
A
)
Always use a wooden or plastic
spatula to avoid damaging the
cooking plate.
Never heat up the appliance
without its two plates in place.
Remove any
Advertisement
Table of Contents
