Chapter 5 Scan; Memory Scan; Group Scan; All-Channel Scan - Kenwood TS-50S Instruction Manual

5 SCAN
MEMORY SCAN
The transceiver will scan all memory channels
containing data (All-channel Scan) or only the selected
channel group (Group Scan). For the selection
method, refer to Menu Set-up (Menu A, No. 13). The
factory default is Group Scan.
GROUP SCAN
There are 100 memory channels, divided into groups
of 10 channels (00 to 09, 10 to 19, ... , 90 to 99). The
transceiver scans only memory channels which belong
to the specified group and contain data.
1 Press the M/V button to change from VFO to
Memory Channel mode. The last memory channel
number selected appears.
SPUT SlOVll
M.Di
j
[J
8
r;
2 Use the UP or DOWN button to select any
memory channel belonging to the desired group.
Adjust the SOL control while no signal is present.
Example: To scan channels 10 to 19, select
memory 12, for instance.
,<ow
:'2 I ' - /.
(I
5 3 [/ "",
" .040
s_
• " a
iO USB
3 Press the SCAN button. The transceiver scans the
specified group.
4 To switch the channel group during scan, use the
microphone UP and DWN buttons.
S To stop scan, press the SCAN or CLR button, or
press the microphone PTT button momentarily.
6 To restore the VFO mode, stop scan and then
press the M/V button, or press the M
>
V button to
transfer the memory data to the VFO.
37
ALL·CHANNEL SCAN
Scan all memory channels containing frequency data
with this procedure:
1
Press the M/V button to change from VFO to
Memory Channel mode. The last memory channel
number selected appears.
2
Adjust the SOL control while no Signal is present.
Remember, Menu A, No.13 must be ON.
Moe
I '-/. ,-J C J II
12
I . _ _ I.J.LI,",
9 "0 40 GOdo
4 • " " u USB
Press the SCAN button. The SCAN indicator
appears, and all occupied memory channels are
scanned.
SPUT SLOW
M.CH
j
[J
8
L
f .
(I
3 5. [/ ' " ,
p
" zo
40 GDdB
3 The UP and DOWN buttons on the transceiver
and microphone operate during scan.
4 To stop scan, press the SCAN or CLR button. Or,
momentarily press the microphone PTT button.
S To restore the VFO mode, stop scan and press
the M/V button, or press the M
>
V button to
transfer the memory data to the VFO.
Note:
if no data
IS
stored
In
the memOries,
or you
have
locked-out all memories, pressing the SCAN key Will sound
the Morse code "CHECK" reminder.