Mounting - Mitsubishi ME110NSR User Manual

Installation 2. Mounting
1 Dimensions of the panel
The panel hole dimensions are as shown below. And it
can be attached to a panel of thickness 1.6 - 4.5mm.
2 View angle
The contrast of the display changes at view angles.
View angle
10°
60°
(Viewed from
the side)
3 Attachment
When to insert the main body into the panel hole, insert it slowly until the stopper at the bottom of the main body
goes into the panel. After insertion, the effect of the stopper prevents the main body from dropping off even when
you release your hand from it.
Stopper
Panel
Fasten the attachment nut (M5 nut with belleville
spring) with torque about 1.47 - 1.96Nm.
A protective sheet is attached to the display for protection against scratch at attachment to
panel. Before starting operation, remove the protective sheet. When you remove it, the
display may be lit owing to generation of static electricity, but it is not an error. It goes off
Note
by natural discharge after a while.
In the case to attach it to the end of the panel, check the wiring work space and decide the
attachment position.
(Viewed from
the top)
● Notes in assembling to the panel and detaching from it
In the meter with output functions, part of its terminal block protrudes from
the cylindrical main body, to which pay attention in attaching and detaching.
Protective sheet
Attachment position
48
±1
90
2-f6
Panel hole dimensions
(Viewed from the front of panel)
Insert or take out the meter
main body right diagonally.
Nut with belleville
spring
Stopper