#2: Supported loads
As a dimmer it operates under the following loads:
•
120V operated conventional incandescent and halogen light
sources
•
12V operated ELV halogen lamps and dimmable LED bulbs (with
electronic transformers)
•
12V operated MLV halogen lamps (with ferromagnetic
transformers)
•
dimmable LED bulbs
•
dimmable compact fluorescent CFL tube lamps
•
supported dimmable light sources (power factor > 0.5) with
minimal power of 5VA using FIBARO Bypass 2 (depending on the
type of load)
Without dimming function it may work with:
•
compact fluorescent CFL tube lamps with electronic ballast
•
fluorescent tube lamps with electronic ballast
•
LED bulbs (power factor > 0.7)
•
supported light sources (power factor > 0.5) with minimal power
of 5VA using FIBARO Bypass 2 (depending on the type of load)
Applied load and the Dimmer 2 itself may be damaged if
!
the applied load is inconsistent with the technical specifi-
cations!
When connecting FIBARO Dimmer 2 act in accordance with the
following rules:
•
Do not connect loads greater or less than those recommended
•
Do not connect different types of light sources simultaneously
•
Do not connect the power supply without a load
•
Do not connect more than one transformer with Dimmer 2 output
•
When using magnetic transformer load it with 50% of its nominal
power at minimum
•
Minimize number of electronic transformers in a circuit, noises
caused by them in electrical grids may affect Dimmer's operation
5
!
CAUTION
FIBARO
Dimmer
2
supports only com-
pact fluorescent tube
lamps and fluorescent
tube lamps with elec-
tronic ballast. Do not
connect other types
of fluorescent lamps!
i
NOTE
You will find more
about FIBARO Bypass
2 in chapter #3 on
page 7.
SUPPORTED LOADS