Audiovox VOD285P Installation Manual

Audiovox VOD285P Installation Manual

Dual 8.5" overhead lcd monitor with dual dvd player
Hide thumbs Also See for VOD285P:

Advertisement

Quick Links

®
VOD285S / VOD285P
DUAL 8.5" OVERHEAD
LCD MONITOR WITH
DUAL DVD PLAYER

Installation Guide

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the VOD285P and is the answer not in the manual?

Questions and answers

Summary of Contents for Audiovox VOD285P

  • Page 1: Installation Guide

    ® VOD285S / VOD285P DUAL 8.5" OVERHEAD LCD MONITOR WITH DUAL DVD PLAYER Installation Guide...
  • Page 2: Important Notice

    If this is the case, an optional relay box is available. The Audiovox part number is SIRSWB and it plugs into the 1/8" jack located next to the FM antenna on the side of the chassis. This relay box is installed between the vehicle antenna and the car radio to provide the best possible FM reception of the DVD player audio.
  • Page 3: Materials Included In This Package

    MATERIALS INCLUDED IN THIS PACKAGE: 1) VOD285S/P TV / Video Monitor with DVD – (1 pc) 2) 12 Pin Power / Signal harness (P/N 112-3483) – (1 pc) 3) 2 Pin Power Wire Harness with choke (P/N 112B3143) – (1 pc) 4) Hardware Package #4 x 5/16"...
  • Page 4: General System Configurations

    GENERAL INSTALLATION APPROACH: 1) Decide upon system configuration and options that will be installed (i.e.: what components, VCP, Video Game, external amp, wireless headphones, VCP, etc.). 2) Review all manuals to become familiar with electrical requirements and hook ups. 3) Decide upon mounting locations of all components and method of mounting. 4) Prep the vehicle by removing any interior trim necessary to gain access to vehicle's wiring as well as all areas where interconnecting wire harnesses will need to be located.
  • Page 5: Vehicle Preparation

    VEHICLE PREPARATION: 1) Locate an accessory power source (+12v when key is in the ACC. and run positions, and 0v when key is off), and also a good ground generally, these wires can be found at the ignition switch or fuse-box. 2) The mounting method and location will vary from vehicle to vehicle, so this manual will only focus on the installation of the VOD285 and related console accessories.
  • Page 6: Trim Ring Installation

    TRIM RING INSTALLATION: This page only covers special installation considerations for the trim ring installation. If the video monitor is to be installed in a vehicle with the trim ring, it may need to be trimmed to fit the contour of the vehicle headliner.
  • Page 7 MOUNTING THE TRIM RING Roof Roof Support Headliner Mounting Bracket Self-drilling Screws Trim Ring Video Unit Washer M5 x10mm Screw...
  • Page 8: Unit (Back View)

    VOD285 Auxillary Video Display Dome Light Power source Power Harness Power Harness Item #3 Item #3 DIN 1 (AV1) Accessory Harness - Optional (P/N:8010730) (Optional) "Y" Adapter Power Connector for use with 4 Pin Non-Stereo Installations Clean the IR Receiver Window on the front of the VCP. Item# 5 Remove Adhesive Backing and Apply IR LED to IR ANT.IN...
  • Page 9 VOD285 1) Make the connections to the vehicle for the 12 pin wiring harness. 2) Connect power harness to vehicle’s electrical system by tapping into an accessory hot line and a good ground. 3) Connect the 12 pin harness to the mating connector on the Video Monitor. 4) If an auxiliary video input is used (VCP, DVD, etc) insert the Circular Mini-Din Connector of the source component harness through the wire tie loop on the main PCB and into the Mini-Din Connector on the main PCB.
  • Page 10: Connecting The Dome Lights

    CONNECTING THE DOME LIGHTS The dome lights in the video monitor require three connections to the vehicle's wiring. There are two common types of dome light circuits used, positive or negative switched. Positive systems supply voltage to the interior lights to turn them on, negative switched systems apply ground to illuminate the bulbs. To determine which system you have you must locate the wires at the dome light.
  • Page 11: Troubleshooting

    Negative Switched Dome Lighting To 12 pin connector Factory Door ajar switch or Body Control computer Troubleshooting: SYMPTOM: No power at Video Monitor Power but no video or sound Static on TV Stations (Tuner Version Only) No Infrared remote functions for VCP (or other components) (page 6 Wiring Diagram) is properly attached to the sensor window of Red / black - Lamp on Black / red - Lamp common...
  • Page 12 For Customer Service Visit Our Website At .audiovox.com Product Information, Photos, FAQ’s Owner’s Manuals 128-7543 © Copyright 2006 Audiovox Electronics Corp. 150 Marcus Blvd. Hauppauge, NY 11788...

This manual is also suitable for:

Vod285s

Table of Contents

Save PDF