Kenmore 110.26002012 Use And Care Manual page 10

9. Select cycle settings
I Hot
E× Heavy
Warm
Cool _1
Cored
High
Low
No Spin
ADJUSTS WASH TIME
Once you select a cycle, the default settings
for
that cycle
will
be lit. Press the cycle modifier buttons to change the Wash
Temp, Soil Level, and Spin Speed, if desired.
NOTE: Always read and follow fabric care label instructions
to avoid damage to your garments.
Wash Ternp Suggested Fabrics
Hot
Some cold water is added to save Whites and pastels
energy. This may be cooler than Durable garments
your hot water heater setting.
Heavy soils
Warm
Some cold water may be added, Bright colors
so this will be cooler than what Moderate to light soils
your previous washer provided. ::i
Cool - brlghts/darks
Warm water is added to assist
in soil removal and to help
dissolve detergents.
Cold
Warm water may be added to
assist in soil removal and to help
dissolve detergents.
Colors that bleed or _i
fade
Light soils _i
Dark colors that bleed
or fade
Light soils
10. Select cycle options
11 • Select Start/Pause/Unlock Lid
to begin wash cycle
@
START/PAoUS E
Press the START/PAUSE/UNLOCK LID button to start the wash
cycle. Filling is delayed for several minutes while load balance
is sensed. When the cycle has finished, the CYCLE COMPLETE
indicator will light up. Promptly remove garments after cycle
has completed to avoid odor, reduce wrinkling, and rusting of
metal hooks, zippers, and snaps.
Unlocking the lld to add garments
If you need to open the lid to add 1 or 2 missed garments, you
may do so during the first portion of the sensing step. Press
START/PAUSE/UNLOCK LiD; the lid will unlock once the
washer movement has stopped. This may take several minutes
if the load was spinning at high speed. Then close lid and press
START/PAUSE/UNLOCK LiD again to restart the cycle. If lid is
left open for more than 10 minutes, the water wHJ pump out.
Delay in water fill
Filling is delayed for 2 to 3 minutes to check for load
unbalance. You will hear the hum of the spin prior to filling.
This is normal operation.
Select any other cycle options you may wish to add, if not
previously set. Some cycles will automatically add certain
options such as 2nd Rinse. These can be turned off:, if desired.
NOTE: Not all options are available with all cycles.
I0