Outdoor -29.9ºC to +69.9ºC with 0.1ºC resolution (“OFL” displayed if outside this range) Relative humidity measuring range: Indoor 20% to 95% with 1% resolution (“- -” displayed if outside this range) Indoor Temperature checking interval every 10 seconds Indoor Humidity checking interval every 20 seconds Outdoor Temperature reception every 5 minutes...
OUTDOOR TEMPERATURE TRANSMITTER/433MHZ RECEPTION CHECK To wall mount The outdoor temperature is measured and transmitted every 60 seconds. Before wall mounting, please check that the outdoor temperature The transmission range of the Outdoor Temperature transmitter may be affected by the values can be received from the desired locations.
Page 4
The current sensitivity value (relative air pressure value) will start flashing after If the bars are rising it means that the weather is getting better due to the increase of air exiting the Relative Air Pressure setting. pressure. If the bars go down, it means the air pressure has dropped and the weather is Use the MIN/MAX/+ key to modify the value.
Note: • A single weather tendency indicator will point upward or downward when the difference in air pressure registered is more than 1hPa but less than 2.5hPa within 4 hours. • Two weather tendency indicators pointing upward or downward will be displayed when the air pressure difference has increased or decreased by 2.5hPa or more within 4 hours For every sudden or significant change in the air pressure, the weather icons will update...
Page 6
If the tower icon flashes, but does not set the time or the DCF tower does not appear at The date default of the Weather Station is 1. 1. in the year 1999. Once the radio- all, then please take note of the following: controlled time signals are received, the date is automatically updated.
CHANNEL key LCD1- ALARM, LCD CONTRAST, TIME AND DATE: Pressing the key once: ALARM SETTING: • To toggle between the outdoor transmitters 1, 2 and 3 (if more than one transmitter Press once the ALARM/SET key until the alarm hour digits flash. is used) Use the MIN/MAX/+ or -/HISTORY key to set the hours.
SETTING UP: BATTERY CHANGE: First, insert the batteries into the Weather Station (see “How to install and replace It is recommended to replace the batteries in all units on an annual basis to ensure batteries in the Weather Station” above). Once the batteries are in place, all optimum accuracy of these units.
Page 9
• WIRELESS WEATHER STATION 35.1018 Indoor temperature reading in °C/ºF with minimum and maximum recording • Indoor humidity reading displayed as RH% with minimum and maximum recording Instruction Manual • Outdoor temperature reading (for up to 3 transmitters) in °C/ºF with minimum and...
Need help?
Do you have a question about the 35.1018 and is the answer not in the manual?
Questions and answers