Assembly - Pulse REVSTER Owner's Manual

Assembly

Handlebar Steer Tube Assembly
Tools required: 5 mm hex wrench, 10 mm wrench
1. Depress the push button located on the
rear of the fork and insert the handlebar
steer tube onto the fork. The push button
should align with the locator hole in the
handlebar steer tube and lock the steer tube
securely in place.
Questions or concerns? Visit our website at www.pulsescooters.com for replacement parts and technical support, or call (866) 434-6067.
2. Tighten the bolts with the 5 mm hex
wrench and 10 mm wrench. Tighten bolts
evenly and securely.
c
a
b
3. Align handlebars both vertically and
horizontally (a) onto handlebar steer tube
clamp (b) install handlebar clamp and
hardware (c&d) and tighten evenly and
securely with the 5 mm hex wrench and 10
mm wrench.
d
5